We offer the most modern technology for the regeneration of particulate filters DPF / FAP / SCR / CAT in passenger cars, trucks, buses as well as construction, agricultural and industrial machines.
Our cleaning method guarantees removal of 99% of contamination from soot, ash, engine oil and refrigerant fluid, and remains safe for the core filter element itself.
The previous method of cutting DPF filters entailed considerable costs, as well as the loss of the type approval. According to the current regulations, a car with a cut-out DPF shall not be approved for road traffic. Both cutting and burning of particulate filters are completely ineffective. They lead to a disturbance of the structure and damage to the monolith and, at the same time, do not remove accumulated ash from the inside of the filter.
In the first stage, using an endoscopic camera, the filter is checked for mechanical damage. In case of detecting cracks, melted ceramic inserts or visible traces of mechanical interference in the DPF, it will not be possible to regenerate the filter. In such case, we will not charge a fee for the inspection
We use environmentally friendly detergents that are safe for the catalytic filter cartridge. The whole process takes place in a closed circuit, thanks to the largest filtration system on the market, it is safe for the natural environment and does not emit any pollutants into the atmosphere.
After tightly sealing the filter in the machine, a back pressure and air flow velocity through the filter are tested. A special cleaning agent is injected into the filter at the next stage. Our detergent is a product of one of the largest producers of chemicals in Europe. The detergent helps dissolve filter dirt and also protects its structure.
Washing is carried out in 3 stages. The first step involves cleaning against the direction of the flow.
The filter is cleaned in appropriate water filling and flow sequences as well as blasts of compressed air.
Washing takes place at 70 degrees.
Our device is the only one on the market that has programs properly selected for each filter size that guarantee proper filling with water and detergent as well as compressed air.
Thanks to the additional air tank and the ability to regulate the pressure as well as properly selected valves, we guarantee that every filter is cleaned in the best possible way.
Depending on the design of the cleaned filter, we select the parameters of the cleaning process in a proper way.
The advantage of our machine lies in the ability to decide on the impact force which guarantees cleaning and, most importantly, the safety of the filter sent to us.
The final stage of washing consists in cleaning again in the opposite direction to the direction of the exhaust gas.
At each stage of cleaning, we analyze impurities coming out of the filter, thanks to which we can determine the reason for pollution and decide on the duration of the entire process.
After blowing out the water remaining in the filter, an additional air heater is activated.
Our device is the only one on the market with a drying temperature above 120 degrees.
After complete drying, the heater is switched off and the filter is cooled down by the blower.
After completing the cleaning process, we test back pressure and flow rate. A report is printed and attached to the filter
If the pressure and speed parameters are unsatisfactory, we return to the beginning of the washing process.
